ASA S12.12
使用声强法确定噪声源声功率级的工程测定法-ASA 104
Engineering Method for the Determination of Sound Power Levels of Noise Sources Using Sound Intensity-ASA 104
ASA S12.31
在混响室中确定宽带噪声源声功率级的精密测定法
Precision Methods for the Determination of Sound Power Levels of Broad-Band Noise Sources in Reverberation Rooms
ASA S12.33
在专用混响测试室中确定噪声源声功率级的工程测定法
Engineering Methods for the Determination of Sound Power Levels of Noise Sources in a Special Reverberation Test Room
ASA S12.34
反射平面上实质自由场条件下噪声源的声功率级的工程测定法
Engineering Methods for the Determination of Sound Power Levels of Noise Sources for Essentially Free-Field Conditions over a Reflecting Plane
ASA S12.35
在消声室和半消声室中确定噪声源声功率级的精密测定法-ASA 90
Precision Methods for the Determination of Sound Power Levels of Noise Sources in Anechoic and Hemi-Anechoic Rooms-ASA 90
ASA S12.36
确定噪声源声功率级的调查测定法
Survey Methods for the Determination of Sound Power Levels of Noise Sources
ASTM D 149
固体电绝缘材料在商用电源频率下的介电击穿电压和介电强度的标准试验方法
Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
ASTM D 635
塑料在水平位置时燃烧速率和/或燃烧蔓延程度及燃烧时间的标准试验方法
Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizontal Position
IEC 60034-1
旋转电机第1部分：额定值和性能
Rotating electrical machines Part 1: Rating and performance
IEC 60034-14
旋转电机第14部分：轴中心高56mm及以上的电机可靠机械振动强度的测量、评价和极限值
Rotating electrical machines Part 14: Mechanical vibration of certain machines with shaft heights 56 mm and higher Measurement, evaluation and limits of vibration severity
IEEE 1
推荐规程 - 电子设备额定值中温度极限和电绝缘评定的一般原则
Recommended Practice - General Principles for Temperature Limits in the Rating of Electrical Equipment and for the Evaluation of Electrical Insulation
IEEE 100
IEEE 标准术语权威辞典
The Authoritative Dictionary of IEEE Standards Terms
IEEE 112
多相感应电动机和发电机的标准试验规程
Standard Test Procedure for Polyphase Induction Motors and Generators
IEEE 115
指南：同步电机的试验程序第1部分：验收和性能试验，第2部分：动态分析的测试程序控制和参数测定
Guide: Test Procedures for Synchronous Machines Part I Acceptance and Performance Testing Part II Test Procedures and Parameter Determination for Dynamic Analysis
IEEE 117
不规则缠绕交流电机绝缘材料系统的评定标准试验程序
Standard Test Procedure for Evaluation of Systems of Insulating Materials for Random-Wound AC Electric Machinery
IEEE 275
采用额定电压6900V及以下电机模绕预绝缘定子线圈的交流电机绝缘系统的热评定推荐规程
Recommended Practice for Thermal Evaluation of Insulation Systems for Alternating-Current Electric Machinery Employing Form-Wound Preinsulated Stator Coils for Machines Rated 6900 V and Below
IEEE 304
直流电机用绝缘系统评定及分类的试验规程
Test Procedure for Evaluation and Classification of Insulation Systems for Direct-Current Machines
IEEE 43
检测旋转电机绝缘电阻的推荐实施规范
Recommended Practice for Testing Insulation Resistance of Rotating Machinery
IEEE 522
交流旋转电机用模绕定子线圈的匝间绝缘试验指南
Guide for Testing Turn Insulation of Form-Wound Stator Coils for Alternating-Current Electric Machines
IEEE 85
旋转电机之上的大气噪声试验程序
Test Procedure for Airborne Sound Measurements on Rotating Electric Machinery
ISO 1000
国际单位制 (SI) 和国际单位制多功能与某些其它单位建议规范
SI Units and Recommendations for the Use of Their Multiples and of Certain Other Units
ISO 10816-3
机械振动 – 通过在非旋转部件上测量，评估机械振动，第3部分现场测量时额定功率在15kW以上、额定速度在120r/分和 15 000 r/分之间
Mechanical Vibration - Evaluation of Machine Vibration by Measurements on Non-Rotating Parts - Part 3: Industrial Machines with Nominal Power Above 15 kW and Nominal Speeds between 120 r/min and 15 000 r/min When Measured In Situ
ISO 3741
声学 – 用声压测定噪声源声音功率级 – 回响室中的精密方法
Acoustics - Determination of Sound Power Levels of Noise Sources Using Sound Pressure - Precision Methods for Reverberation Rooms
ISO 3743-1
声学 – 噪声源声功率级的测定 – 在回响声场中小声源和移动声源的工程测量方法，第1部分： 硬墙试验室中的比较法，第一版；(CEN EN ISO 3743-1: 1995}
Acoustics - Determination of Sound Power Levels of Noise Sources - Engineering Methods for Small, Movable Sources in Reverberant Fields Part 1: Comparison Method for Hard-Walled Test Rooms First Edition; (CEN EN ISO 3743-1: 1995)
ISO 3743-2
声学 – 噪声源的声功率级的测定 – 回响声场中小型可移动声源工程法 – 第2部分：专用回响试验室法
Acoustics - Determination of Sound Power Levels of Noise Sources Using Sound Pressure - Engineering Methods for Small, Movable Sources in Reverberant Fields - Part 2: Methods for Special Reverberation Test Rooms
ISO 3744
声学 – 声压法测定噪声源的声功率级 – 在反射层上本质上自由场中的工程法
Acoustics - Determination of Sound Power Levels of Noise Sources Using Sound Pressure - Engineering Method in an Essentially Free Field over a Reflecting Plane
ISO 3746
声学 – 声压法测定噪声源的声功率级 – 采用在反射层表面进行测量方法 (CEN EN ISO 3746: 1995)
Acoustics - Determination of Sound Power Levels of Noise Sources Using Sound Pressure - Survey Method Using an Enveloping Measurement Surface over a Reflecting Plane (CEN EN ISO 3746: 1995)
ISO 3747
声学 – 利用声压测定噪声源的声功率级 – 现场比较法
Acoustics - Determination of Sound Power Levels of Noise Sources Using Sound Pressure - Comparison Method in Situ
ISO 7919-1
非往复式机械的机械振动 – 对旋转轴的测量和评定规范 – 第1部分：通用指南
Mechanical Vibration of Non-Reciprocating Machines - Measurements on Rotating Shafts and Evaluation Criteria - Part 1: General Guidelines
ISO 8528-3
往复式内燃机驱动的交流发电机组.第3部分：发电机组交流发电机
Reciprocating Internal Combustion Engine Driven Alternating Current Generating Sets - Part 3: Alternating Current Generators for Generating Sets
ISO 8528-4
往复式内燃机驱动的交流发电机组 – 第4部分：控制装置和开关装置
Reciprocating Internal Combustion Engine Driven Alternating Current Generating Sets - Part 4: Controlgear and Switchgear
ISO 9614-1
声学 – 声强法测定噪声源声功率级 – 第1部分： 离散点测量法 (CEN EN ISO 9614-1: 1995)
Acoustics - Determination of Sound Power Levels of Noise Sources Using Sound Intensity - Part 1: Measurement at Discrete Points (CEN EN ISO 9614-1: 1995)
ISO 9614-2
声学 – 声强法测定噪声源的声功率级 – 第2部分：扫描测量法
Acoustics - Determination of Sound Power Levels of Noise Sources Using Sound Intensity - Part 2: Measurement by Scanning
NEMA C84.1
电力系统和设备 – 电压额定值60赫兹
Electric Power Systems and Equipment - Voltage Ratings (60 Hertz)
NEMA MG 2
选择、安装和使用电动机和发电机的安全标准与指南
Safety Standard and Guide for Selection, Installation, and Use of Electric Motors and Generators
NEMA MG 3
已安装旋转电机的声级预测
Sound Level Prediction for Installed Rotating Electrical Machines
SAE B92.1
渐开线花键
Involute Splines
SAE J429
外部螺纹紧固件的机械和材料要求
Mechanical and Material Requirements for Externally Threaded Fasteners
|